FedGovContracts.com

Panoptic Enterprises' FEDERAL CONTRACTS DISPATCH

DATE: October 27, 2003

SUBJECT: Small Business Administration; Termination of Nonmanufacturer Rule Waiver for Small Arms Ammunition Manufacturing

SOURCE: Federal Register, October 27, 2003, Vol. 68, No. 207, page 61097

AGENCIES: Small Business Administration (SBA)

ACTION: Termination of Nonmanufacturer Rule Waiver

SUMMARY: The SBA is terminating its waiver of the nonmanufacturer rule for small arms ammunition manufacturing. This decision is based on SBA's discovery of small business manufacturers for these products.

EDITOR'S NOTE: For more on the waiver of the nonmanufacturer rule for small arms ammunition manufacturing, see the September 6, 2002, FEDERAL CONTRACTS DISPATCH "Small Business Administration; Waiver of the Nonmanufacturer Rule for Small Arms Ammunition Manufacturing."

For more on the notice of intent to terminate the waiver, see the July 9, 2003, FEDERAL CONTRACTS DISPATCH "Small Business Administration; Termination of Nonmanufacturer Rule Waiver for Small Arms Ammunition Manufacturing."

The SBA regulation on the nonmanufacturer rule is in Title 13 of the Code of Federal Regulations (CFR), Business and Credit Administration, Part 121, Small Business Size Standards, under paragraph (b) of 121.406, How Does a Small Business Concern Qualify to Provide Manufactured Products Under Small Business Set-Aside or MED [Minority Enterprise Development] Procurements? The SBA regulation on the waiver of the nonmanufacturer rule is 13 CFR 121.1202, When Will a Waiver of the Nonmanufacturer Rule Be Granted for a Class of Products?

A complete list of products for which the nonmanufacturer rule has been waived is available at http://www.sba.gov/GC/approved.html.

EFFECTIVE DATE: October 27, 2003.

FOR FURTHER INFORMATION CONTACT: Edith Butler, Program Analyst, U.S. Small Business Administration, 409 3rd Street, SW, Washington, DC 20416; 202-619-0422.

SUPPLEMENTAL INFORMATION: Public Law 100-656, enacted November 15, 1988, requires recipients of federal contracts that are set-aside for small businesses or are awarded through the SBA's 8(a) program for disadvantaged small businesses to provide the product of a small business manufacturer or processor if the recipient is not the actual manufacturer or processor. This is called the "nonmanufacturer rule" (see paragraph (f) of Federal Acquisition Regulation (FAR) 19.102, Size Standards). However, the law permits SBA to waive this requirement for any "class of products" if there are no small business manufacturers or processors in the federal market.

SBA published a notice on September 6, 2002, that it was granting a nonmanufacturing rule waiver for small arms ammunition manufacturing within North American Industry Classification System (NAICS) 332992. SBA granted the waiver because it was unaware of any small business sources for these items and it received no comments when it published its intent to grant such a waiver.

However, it was brought to SBA's attention by a small business manufacturer and SBA's Procurement Center Representatives that a small business manufacturer exists for items within this class of products. Therefore, SBA published a notice of its intent to terminate the waiver granted for small arms ammunition manufacturing, and invited the public to comment on its proposal to terminate the waiver. Comments were received in response to the notice from small business manufacturers, so SBA is required to terminate the waiver of the nonmanufacturer for small arms ammunition manufacturing under NAICS 332992.

This waiver termination will require recipients of contracts set aside for small or 8(a) businesses to provide the products of small business manufacturers or processors on such contracts.

FOR FURTHER INFORMATION CONTACT: Panoptic Enterprises at 703-451-5953 or by e-mail to Panoptic@FedGovContracts.com.

Copyright 2003 by Panoptic Enterprises. All Rights Reserved.

Return to the Dispatches Library.

Return to the Main Page.